We are a Crafts Molding Silicone Factory. Today we share with you some questions about the injection molding process of liquid silica gel. I hope the above knowledge can help you.
1. To avoid turbulence and jet, use small injection nozzle.
2. Use needle or winglike glue injection port.
3. Replace the column type guide bolt with t-type guide bolt, and use the air gun to add the heat insulation layer/plate when removing the mold.
4. Do not use antirust agent/oil containing anticoagulant, generally toluene, xylene, etc.
Liquid Silicone Rubber is divided into A Rubber and B Rubber. The ratio of the two is 1:1 by using A quantitative device. The Liquid Silicone Rubber is fully mixed through A Static Mixer. Liquid silica gel can be injected into the mould of hot runner to make silica gel products, so it can reach the advantages of waste free and automatic during primary molding.
We provide Moldable Silicone Rubber and Platinum Cure Silicone for Jewelry Molds. If you want to know our products, welcome to contact us!
Copyright © GUOCHUANG SILICONE CO., LTD. All Rights Reserved
Sitemap
